Diskless profiles had the updatestatus callback in onboot.sh commented
out because no suitable status existed: 'complete' clears
deployment.pendingprofile, which the PXE responder requires to answer
the next network boot of a diskless node.
Add a 'booted' status that records the pending profile as
deployment.profile while leaving pendingprofile armed and skipping
autolock, and enable the onboot.sh callback in all diskless profiles.
nodedeploy now shows 'pending: <profile> (booted)' for a running
stateless node.
BUILDSRC is only set if imgutil build is run with --source, otherwise
the build host repos are used. If --source is not used, there is no
distribution symlink and add_local_repositores failed with 404.
Check if BUILDSRC is set and skip add_local_repositories if this is the
case.
Centralize the SELinux chcon helper and use it for downloaded
systemd units, onboot hooks, and apiclient files across EL7 through EL10.
Include chcon in captured EL initramfs images.
Without this fix the onboot services failed to start on SELinux enabled
captured image.
This allows the FS to just live, uncompressed, in cache.
This is generally a bad idea, however:
- In a hypothetically super-tuned diskless image, the lack of double-cache can offset the lack of compression
- The image will have supreme read performance
- It will have the most deterministic memory behavior
Add missing pre.d directory to let user know they can use such scripts
Preserve console directievs from kernelargs into installed system
Retry umount during image2disk, if processes have the filesystem busy.
Fix DNS behavior during post phase of installtodisk
Invoke confignet properly during firstboot to set up additional interfaces.
Have sshd run during the install from '/sysroot', for convenience
Fix some cosmetic error output for setupssh
Reduce obvious output about skipped devices.
Rule out any read-only device.
Amend minimum size to 2GB.
Among same priority devices, select the smallest target.
Node attribute ntp.servers in nodeattrib ca now be used in stateless images
modified: confluent_osdeploy/el7-diskless/profiles/default/scripts/onboot.sh
modified: confluent_osdeploy/el8-diskless/profiles/default/scripts/onboot.sh
modified: confluent_osdeploy/el9-diskless/profiles/default/scripts/onboot.sh
A variant of the M.2 RAID enablement kit does not manifest with nvme
driver. Address this by allowing 'nvm' subsystype. to allow blank driver.
Also, to be on the safe side, have self.driver always be a string,
so it can be 'falsey' but still work as a string.
If syncfiles fails, keep it retrying.
Also, slow down sync checking to avoid hammering the system.
Further, randomized delay to spread highly synchronized requestors.
Block attempts to do multiple concurrent syncfile runs.
Some versions start manifesting nvme devnames with 'c', which
are to be used to interact with multipath to have raw devices
backing a traditional nvme device.
With significant firstboot output, there was a tendency
for tail to be killed before it relayed all the content.
Change to run the firstboot in a subshell in the background,
and have tail explicitly run until that subshell naturally
exits and then tail will cleanly exit
It is likely that a client connects from fe80::, which
is explicitly omitted from ssh principals.
This time, have the client provide all currently set IP addresses
and the server will make a determination.
There remains the possibility it misconfigures a nic and tries to use that,
inducing failure. One strategy would be to filter the addresses and
only provide from the 'current' interface. Another is to just take
the hit as the node is likely going to suffer a lot from such a
misconfiguration anyway.
Markus Hilger
Jarrod Johnson
Jarrod Johnson
Wera Grzeda